While the other person holds the frame up to the wall, you can stand back and decide which height is best to display your picture and then mark the wall lightly with a pencil at the top center of the frame. Unless you’re hanging a fairly small frame, this is where it can be handy to have a second person’s help. If you can see the wire over the top of the frame, you’ve gone too high. The wire should extend up into the middle of the space between the top of the frame and the screw eyes. For frames made of metal, there should be sliders in about the same spot. This wire should then be attached to screw eyes, which are driven into the wood of the frame about 2/3 up from the bottom. The heavier the frame, the thicker the gauge of wire needed. If the gauge of wire is too thin, it could break and send your framed piece crashing to the floor. Now that you have decided on the location your art should hang and picked the correct hanging device for your wall type, it’s time to take a look at the wire that will be supporting the weight of the frame. Step 2 - Hanging Your Picture With Gauge Wire However, when you insert the screw or hook, be sure it is large enough to support the weight you need once it goes in and the epoxy dries, it’s not going to come back out easily. As soon as the epoxy dries, you can start hanging the photo. In addition, a little bit of epoxy can be inserted into the drilled hole. To hang a frame on brick or masonry, you will generally use the same process as you would for plaster. This will give a little extra grip in supporting the frame and make sure the screw doesn’t slip back out. You’ll want to drill a hole and use a wall anchor, which is a sleeve inserted into a drilled hole that will expand as a screw is driven into it. PlasterĪlthough plaster tends to hold fasteners better than drywall, forget about the hammer and nail. It grips the wall from the inside as it is tightened. A toggle bolt has “wings” that slide through a hole drilled into the wall and expand after it has been pushed through. Besides using two picture hooks, a more reliable way to provide support is to install a toggle bolt. Be sure to hammer the nail in at an angle to provide more support.įor bigger pictures hung on drywall, you may want to use additional support with a fastener. Usually, you can find the right hook by looking at the weight limits on the hook packaging. The lighter the frame, the simpler the picture hook needs to be. If there is no stud in the space where you want your picture to be, you can still hang up your piece using an appropriately sized picture hook. When you hear the “thud,” that’s the stud. If you don’t have one of these devices, you can pick one up for cheap, or you can just tap around on the wall to find studs. However, because drywall is soft, use an electronic stud finder to locate a vertical beam of wood in the wall to hang your picture on. Inserting a picture hook into drywall is fairly uncomplicated.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |